Installation Guide
Table Of Contents
- Warning
- Overview
- Tyco Illustra Pro 5MP Thermal Elevated Skin Temperature Detection Camera
- Network Topology
- Network Connection
- Live View
- Search
- Configuration
- Appendix A - Shutdown Procedure
- Appendix B: Using Media Player to View RTSP Streaming
- Appendix C: Technical Specifications
- Appendix D - Manufacturer and Local Contact Information
- Disclaimer and Regulatory
- EMC Information
- End User License Agreement (EULA)
Tyco Illustra Pro 5MP Thermal Elevated Skin Temperature Detection Camera Installation and Configuration
8200-1953-09 A0 67
d Enter the Gateway IP address in Gateway text box xxx.xxx.xxx.xxx.
e Enter the Preferred DNS Server IP address in the Preferred DNS Server text box.
f Enter the Alternate DNS Server IP address in the Alternate DNS Server text box.
3 Select the Save button to save the settings.
- End -
Procedure 68 Configure the IPv6 settings
1 Select Network on the Web User Interface banner to view the IPv4 tab.
1 Select the IPv6 tab.
2 Select the Obtain an IP address automatically option to automatically enable DHCP and
disable manual settings.
Or
Select the Use the following IP address option to manually enter the settings.
a Select the IP Address text box and enter the IP address.
b Select the Subnet Prefix Length text box and enter a value.
c Select the Gateway text box and enter the Gateway number.
3 Select the Save button to save the settings.
- End -
Procedure 69 Configure the PPoE Config settings
1 Select Network on the Web User Interface banner to view the IPv4 tab.
2 Select the PPoE Config tab.
3 Select the Enable check box to enable PPPoE.
4 Select the User Name text box and enter a username.
5 Select the Password text box and enter a password.
6 Select the Save button to save the settings.
Note:If PPPoE is used to connect to the internet, the camera receives a dynamic
WAN IP address. This IP address changes frequently. To be notified, the IP change
notification function can be used.
- End -
Procedure 70 Configure the IP Change Notification Config settings
1 Select Network on the Web User Interface banner to view the IPv4 tab.
2 Select the IP Change Notification Config tab.
3 Select the Trigger Email check box so that when the IP address of the device is changed,
the new IP address is sent to the email address that has been set up.
Or
Select the Trigger FTP check box so that when the IP address of the device is changed,
the new IP address is sent to FTP server that has been set up.