Installation Guide
Table Of Contents
- Warning
- Overview
- Tyco Illustra Pro 5MP Thermal Elevated Skin Temperature Detection Camera
- Network Topology
- Network Connection
- Live View
- Search
- Configuration
- Appendix A - Shutdown Procedure
- Appendix B: Using Media Player to View RTSP Streaming
- Appendix C: Technical Specifications
- Appendix D - Manufacturer and Local Contact Information
- Disclaimer and Regulatory
- EMC Information
- End User License Agreement (EULA)
66 8200-1953-09 A0
Network
In this section you can configure the IPv4, IPv6 and PPPoE settings on the camera. If PPPoE is
used to connect to the internet, the camera receives a dynamic WAN IP address. This IP address
changes frequently. To be notified, the IP change notification function can be used.
You can also configure settings for the ports, server, DDNS, 802.1x, RTSP, UPnP, Email, FTP,
HTTPS, Spvmn and Quality of Service (QoS).
Figure 32 Network settings menu page
TCP/IP
In this section you can configure the IPv4, IPv6 and PPPoE settings on the camera. If PPPoE is
used to connect to the internet, the camera receives a dynamic WAN IP address. This IP address
changes frequently. To be notified, the IP change notification function can be used.
Procedure 67 Configure the IPv4 settings
1 Select Network on the Web User Interface banner to view the IPv4 tab.
2 Select the Obtain an IP address automatically option to automatically enable DHCP and
disable manual settings.
Or
Select the Use the following IP address option to manually enter the settings.
a Enter the IPv4 Address in the IPv4 Address text box in the form xxx.xxx.xxx.xxx. The
default setting is ‘192.168.1.168’
b Select the Test button to ensure that the IP address is correct.
c Enter the Subnet Mask in the Subnet Mask text box xxx.xxx.xxx.xxx. The default set-
ting is ‘255.255.255.0’