Installation Guide
Table Of Contents
- Warning
- Overview
- Tyco Illustra Pro 5MP Thermal Elevated Skin Temperature Detection Camera
- Network Topology
- Network Connection
- Live View
- Search
- Configuration
- Appendix A - Shutdown Procedure
- Appendix B: Using Media Player to View RTSP Streaming
- Appendix C: Technical Specifications
- Appendix D - Manufacturer and Local Contact Information
- Disclaimer and Regulatory
- EMC Information
- End User License Agreement (EULA)
60 8200-1953-09 A0
Note:To save snapshots to the local PC, please enable “Local Smart Snapshot
Storage” in the local config interface first. To save snapshots to the SD card, please
install an SD card first.
5 Select one of the following Detection Target check boxes to enable an alarm:
• Human: Alarms will be triggered if someone crosses the pre-defined
alarm lines.
• Motor Vehicle: Alarms will be triggered if a vehicle with four or more
wheels (eg. a car, bus or truck) crosses the pre-defined alarm lines.
• Motorcycle/Bicycle: Alarms will be triggered if a non-motor vehicle
(eg. a motorcycle or bicycle) crosses the pre-defined alarm lines.
Move the slide-bar to increase or descrease the sensitivity.
Note:These three types of objects can be selected simultaneously. Please select
the detection objects as needed. If no object/target is selected, alarms will not be
triggered even if line crossing detection is enabled.
6 Select the Timing drop-down menu and select an option.
The current number of the targets to be counted can be reset. You can choose to reset the
counting daily, weekly or monthly.
7 Select the Reset button to manually reset the current number of crossing line
people/car/bike counting.
8 Select the Save button to save the settings.
- End -
Procedure 57 Configure a target counting area
1 Select Alarm and Event on the Web User Interface banner and then select Target Count-
ing.
2 Select the Area tab.
3 Select the Alarm Line drop-down menu and select and an alarm line number.
4 Select the Direction drop-down menu and select the line direction. Only one alarm can be
added. See all line direction options explained below.
Note:A<->B, A->B and A<-B optional. This indicates the direction of the
intruder/vehicle crosses over the alarm line.
Note:A<->B: The alarm will be triggered when the intruder/vehicle crosses over the
alarm line from B to A or from A to B.
Note:A->B: The alarm will be triggered when the intruder/vehicle crosses over the
alarm line from A to B.
Note:A<-B: The alarm will be triggered when the intruder/vehicle crosses over the
alarm line from B to A.
5 Select the Draw Area button and then click and drag the mouse over the video and draw
rectangular border lines.
Select the Clear button to delete the alarm area.