Installation Guide
Table Of Contents
- Warning
- Overview
- Tyco Illustra Pro 5MP Thermal Elevated Skin Temperature Detection Camera
- Network Topology
- Network Connection
- Live View
- Search
- Configuration
- Appendix A - Shutdown Procedure
- Appendix B: Using Media Player to View RTSP Streaming
- Appendix C: Technical Specifications
- Appendix D - Manufacturer and Local Contact Information
- Disclaimer and Regulatory
- EMC Information
- End User License Agreement (EULA)
Tyco Illustra Pro 5MP Thermal Elevated Skin Temperature Detection Camera Installation and Configuration
8200-1953-09 A0 59
Note:For example, if 5 seconds is selected, the camera will capture the same target
once every 5 seconds during its continuous tracking period.
4 Select the Snapshot Number check box and enter a number in the text box.
Note:For example, if the snapshot number is enabled and set (eg. 3), the camera
will capture the same target once every 5 seconds and it will capture this target 3
times at most during its continuous tracking period. If the snapshot number is
disabled, the camera will capture the same target once every 5 seconds until the
target disappears in the detected area.
5 Select the Save button to save the settings.
- End -
Procedure 55 Schedule a face detection alarm
1 Select Alarm and Event on the Web User Interface banner and then select Face
Detection.
2 Select the Schedule tab.
3 See the Schedule section in the Temperature Measurement Schedule section on page 41 for
assistance.
- End -
Configuration requirements of camera and surrounding area
• Cameras must be installed in the area with stable and adequate light sources.
• The installation height ranges from 2.0m to 3.5m, adjustable according to the focal-
length of different lenses and object distances.
• The depression angle of the camera shall be less than or equal to 15°.
• The object distance depends on the focal-length of the lens mounted in the camera.
• To ensure the accuracy of face detection, the captured faces are only allowed to
deviate less than 30° leftward or rightward or 20° upward or downward.
Target Counting
This function is to calculate the number of the people or vehicles crossing the alarm line through
detecting, tracking and counting the shapes of the people or vehicles.
Note:Enabling target counting disables EST temperature measurements.
Procedure 56 Configure a target counting alarm
1 Select Alarm and Event on the Web User Interface banner and then select Target Count-
ing.
2 Select the Enable check box to enable Target Counting.
3 Select the Save Panoramic Picture check box: If it is enabled, the detected panoramic
pictures will be captured and saved to the SD card when there are targets detected.
4 Select the Save Target Cutout check box: If it is enabled, the detected target cutout
pictures will be captured and saved to the SD card when there are targets detected.