Installation Guide
Table Of Contents
- Warning
- Overview
- Tyco Illustra Pro 5MP Thermal Elevated Skin Temperature Detection Camera
- Network Topology
- Network Connection
- Live View
- Search
- Configuration
- Appendix A - Shutdown Procedure
- Appendix B: Using Media Player to View RTSP Streaming
- Appendix C: Technical Specifications
- Appendix D - Manufacturer and Local Contact Information
- Disclaimer and Regulatory
- EMC Information
- End User License Agreement (EULA)
Tyco Illustra Pro 5MP Thermal Elevated Skin Temperature Detection Camera Installation and Configuration
8200-1953-09 A0 57
Select the Stop Draw button to stop drawing.
Select the Clear button to delete the alarm area.
5 Select the Save button to save the settings.
- End -
Procedure 51 Schedule an Intrusion alarm
1 Select Alarm and Event on the Web User Interface banner and then select Intrusion.
2 Select the Schedule tab.
3 See the Schedule section in the Temperature Measurement Schedule section on page 41 for
assistance.
- End -
Configuration of camera and surrounding area
• Avoid the scenes with many trees or the scenes with various light changes (like many
flashing headlights). The ambient brightness of the scenes shouldn’t be too low.
• Cameras should be mounted at a height of 2.8 meters or above.
• Keep the mounting angle of the camera at about 45°.
• The detected objects should not be less than 1% of the entire image and the largest
sizes of the detected objects should not be more than 1/8 of the entire image.
• Make sure cameras can view objects for at least 2 seconds in the detected area for
accurate detection.
• Adequate light and clear scenery are crucial for line crossing detection.
Face Detection
The Face detection function is to detect the face appearing in the surveillance scene. Alarms will be
triggered when a face is detected.
Procedure 52 Configure a face detection alarm
1 Select Alarm and Event on the Web User Interface banner and then select Face
Detection.
2 Select the State text box and enter a state.
3 Select the Enable check box to enable face detection.
4 Select the Save Source Information check box: If it is enabled, the whole picture will be
saved to the SD card when detecting a face.
5 Select the Save Face Information check box: If it is enabled, the captured face picture will
be saved to the SD card when detecting a face.
Note:To save images to the local PC, please enable the local smart snapshot
storage first (Config - System - Local Config). To save images to the SD card,
please install an SD card first.
6 Select the Alarm Holding Time drop-down menu and select an option.
7 Select the following check boxes to trigger that alarm: