Installation Guide
Table Of Contents
- Warning
- Overview
- Tyco Illustra Pro 5MP Thermal Elevated Skin Temperature Detection Camera
- Network Topology
- Network Connection
- Live View
- Search
- Configuration
- Appendix A - Shutdown Procedure
- Appendix B: Using Media Player to View RTSP Streaming
- Appendix C: Technical Specifications
- Appendix D - Manufacturer and Local Contact Information
- Disclaimer and Regulatory
- EMC Information
- End User License Agreement (EULA)
Tyco Illustra Pro 5MP Thermal Elevated Skin Temperature Detection Camera Installation and Configuration
8200-1953-09 A0 55
Note:A<-B: The alarm will be triggered when the intruder/vehicle crosses over the
alarm line from B to A.
5 Select the Draw Area button and click and drag the mouse over the video to draw a line on
the image.
Note:Select the Clear button to delete the lines.
6 Select the Save button to save the settings.
- End -
Configuration of the camera and surrounding area
• Avoid the scenes with many trees or the scenes with various light changes (like many
flashing headlights). The ambient brightness of the scenes shouldn’t be too low.
• Cameras should be mounted at a height of 2.8 meters or above.
• Keep the mounting angle of the camera at about 45°.
• The detected objects should not be less than 1% of the entire image and the largest
sizes of the detected objects should not be more than 1/8 of the entire image.
• Make sure cameras can view objects for at least 2 seconds in the detected area for
accurate detection.
• Adequate light and clear scenery are crucial for line crossing detection.
Procedure 48 Scheduling a line crossing alarm.
1 Select Alarm and Event on the Web User Interface banner and then select LIne Crossing.
2 Select the Schedule tab.
3 See the Schedule section in the Temperature Measurement Schedule section on page 41 for
assistance.
- End -
Intrusion
Alarms will be triggered if the target intrudes and loiters in the pre-defined areas.
Procedure 49 Configure an Intrusion detection
1 Select Alarm and Event on the Web User Interface banner and then select Intrusion.
2 Select the Enable check box to enable intrusion.
3 Select the Save Panoramic Picture check box: If it is enabled, the detected panoramic
pictures will be captured and saved to the SD card when there are targets detected.
4 Select the Save Target Cutout check box: If it is enabled, the detected target cutout
pictures will be captured and saved to the SD card when there are targets detected.
Note:To save snapshots to the local PC, please enable “Local Smart Snapshot
Storage” in the local config interface first. To save snapshots to the SD card, please
install an SD card first.
5 Select one of the following Detection Target check boxes to enable an alarm: