Installation Guide
Table Of Contents
- Warning
- Overview
- Tyco Illustra Pro 5MP Thermal Elevated Skin Temperature Detection Camera
- Network Topology
- Network Connection
- Live View
- Search
- Configuration
- Appendix A - Shutdown Procedure
- Appendix B: Using Media Player to View RTSP Streaming
- Appendix C: Technical Specifications
- Appendix D - Manufacturer and Local Contact Information
- Disclaimer and Regulatory
- EMC Information
- End User License Agreement (EULA)
48 8200-1953-09 A0
Anomaly
In this section you can take an action, such as triggering an alarm, if the SD card is full, has an error
or if the camera experiences some error such as the IP collision or cable disconnection.
Procedure 33 Enable an alarm when the SD Card is full
1 Select Alarm and Event on the Web User Interface banner and then select Anomaly.
2 Select the Enable check box.
3 Select the Alarm Holding Time drop-down menu and select a time.
4 Select one of the following check boxes to trigger the alarm:
• Alarm Out: If enabled, the alarm output device will be triggered when
detecting abnormal temperature.
• Trigger Email: If Trigger Email and Attach Picture are checked (email
address must be set first in the Email configuration interface), the cap-
tured pictures and triggered event will be sent into those addresses.
• Trigger FTP: If Trigger FTP is checked, the captured pictures will be
sent into FTP server address. Please refer to FTP configuration
chapter for more details.
5 Select the Save button to save the settings.
- End -
Procedure 34 Enable an SD Card Error alarm
1 Select Alarm and Event on the Web User Interface banner and then select Anomaly.
2 Select the SD Card Error tab.
3 Select the Enable check box.
4 Select the Alarm Holding Time drop-down menu and select a time.
5 Select one of the following check boxes to trigger the alarm:
• Alarm Out: If enabled, the alarm output device will be triggered when
detecting abnormal temperature.
• Trigger Email: If Trigger Email and Attach Picture are checked (email
address must be set first in the Email configuration interface), the cap-
tured pictures and triggered event will be sent into those addresses.
• Trigger FTP: If Trigger FTP is checked, the captured pictures will be
sent into FTP server address. Please refer to FTP configuration
chapter for more details.
6 Select the Save button to save the settings.
- End -
Procedure 35 Enable an IP Address Collision alarm
1 Select Alarm and Event on the Web User Interface banner and then select Anomaly.
2 Select the IP Address Collision tab.
3 Select the Enable check box.