Installation Guide

Tyco Illustra Pro 5MP Thermal Elevated Skin Temperature Detection Camera Installation and Configuration
8200-1953-09 A0 47
• Trigger Snap: If selected, the system will capture images on motion
detection and save the images on an SD card.
• Trigger SD Recording: If selected, video will be recorded on an SD
card on motion detection.
• Trigger Email: If “Trigger Email” and “Attach Picture” are selected
(email address must be set first in the Email configuration interface),
the captured pictures and triggered event will be sent into those
addresses.
• Trigger FTP: If selected, the captured pictures will be sent into FTP
server address. Please refer to FTP configuration chapter for more
details.
5 Select the Save button to save the settings.
- End -
Procedure 31 Select the motion detection area and sensitivity
1 Select Alarm and Event on the Web User Interface banner to view the Motion tab.
2 Select the Area and Sensitivity tab.
3 Move the Sensitivity slide-bar to set the sensitivity. A higher sensitivity value means that
motion will be triggered more easily.
4 Select Add and then select the Draw Area button.
5 Click and drag the mouse over the screen to draw the motion detection area.
Note:Select the Clear All button and then click and drag the mouse over the
screen to erase the motion detection area.
Note:Select the Select All button to select the full drawing.
Note:Select the Invert button to invert the drawing.
6 Select the Save button to save the settings.
- End -
Procedure 32 Schedule a motion detection alarm
1 Select Alarm and Event on the Web User Interface banner to view the Motion tab.
2 Select the Schedule tab.
3 See the Schedule section in the Temperature Measurement Schedule section on page 41 for
assistance.
- End -