Installation Guide
Table Of Contents
- Warning
- Overview
- Tyco Illustra Pro 5MP Thermal Elevated Skin Temperature Detection Camera
- Network Topology
- Network Connection
- Live View
- Search
- Configuration
- Appendix A - Shutdown Procedure
- Appendix B: Using Media Player to View RTSP Streaming
- Appendix C: Technical Specifications
- Appendix D - Manufacturer and Local Contact Information
- Disclaimer and Regulatory
- EMC Information
- End User License Agreement (EULA)
46 8200-1953-09 A0
Alarm and Event
In this section you can configure motion detection, an SD card, alarm in and out, the alarm server,
audio alarm, light alarm, set the camera to detect changes in the surveillance environment affected
by the external factors, the sensitivity the system responds to the amplitude of the scene change,
trigger alarms and set areas of interest.
Figure 30 Alarm and Event settings menu page
Motion Detection
Procedure 30 Configuring a motion detection alarm
Four video streams can be adjusted at the same time.
1 Select Alarm and Event on the Web User Interface banner to view the Motion tab.
2 Select the Enable check box to activate motion based alarms.
Note:If unchecked, the camera will not send out any signals to trigger motion-based
recording to the NVR or CMS, even if there is motion in the video.
3 Select the Alarm Holding Time drop-down menu and select an option.
4 Select the following check boxes to enable that alarm:
• Alarm Out:If selected, this would trigger an external relay output that
is connected to the camera on detecting a motion based alarm.
• Trigger Audio Alarm: If selected, the warning voice will be uttered on
detecting a motion based alarm. (Please set the warning voice first.
See Audio Alarm for details).