Installation Guide
Table Of Contents
- Warning
- Overview
- Tyco Illustra Pro 5MP Thermal Elevated Skin Temperature Detection Camera
- Network Topology
- Network Connection
- Live View
- Search
- Configuration
- Appendix A - Shutdown Procedure
- Appendix B: Using Media Player to View RTSP Streaming
- Appendix C: Technical Specifications
- Appendix D - Manufacturer and Local Contact Information
- Disclaimer and Regulatory
- EMC Information
- End User License Agreement (EULA)
45 8200-1953-09 A0
Note:The Blackbody target icon will not update the read temperature value until the
page is refreshed or the target icon is repositioned within the Blackbody.
Note:It may take up to 10 minutes to make the temperature module of the camera
stable. Therefore, please measure the body temperature after 10 minutes.
Note:The Blackbody does not support IP40. If the blackbody is used with the
camera, it shall be installed 2 or 3 meters away from the camera. It cannot be
blocked. During operation, do not move the camera and blackbody and make sure
the blackbody is in a fixed and correct position in the camera image.
- End -
Display Settings
In this section you can select a colorization option.
Procedure 29 Selecting a temperature display setting
1 Select Temperature on the Web User Interface banner and then select Display Settings
from the menu list.
2 Select the Colorization drop down menu and select one of the following:
• Iron oxide red
• Rainbox
• White hot
• Black hot
• Green jade
3 Select the Save button to save the settings.
- End -