Installation Guide
Table Of Contents
- Warning
- Overview
- Tyco Illustra Pro 5MP Thermal Elevated Skin Temperature Detection Camera
- Network Topology
- Network Connection
- Live View
- Search
- Configuration
- Appendix A - Shutdown Procedure
- Appendix B: Using Media Player to View RTSP Streaming
- Appendix C: Technical Specifications
- Appendix D - Manufacturer and Local Contact Information
- Disclaimer and Regulatory
- EMC Information
- End User License Agreement (EULA)
Tyco Illustra Pro 5MP Thermal Elevated Skin Temperature Detection Camera Installation and Configuration
8200-1953-09 A0 22
Procedure 5 Connecting from a computer
Step Action
1 Ensure the camera and your computer are in the same subnet.
2 Check if the network is available between the unit and the computer by pinging the default IP
address.
a Start a command prompt.
b Type “Ping 192.168.1.168”. If the message “Reply from…” appears, it means the con-
nection is available.
3 Start Internet Explorer and enter IP address: 192.168.1.168. A login window appears. In the
window, enter the default user name: admin and password: admin to log in.
- End -
DHCP
On initial camera startup, and after a hardware factory reset, Dynamic Host Configuration Protocol
(DHCP) is enabled by default and remains enabled until the camera receives either a DHCP address
or is assigned a Static IP address.
Procedure 6 Configure the IPv4 settings
Step Action
1 Select Network on the Web User Interface banner to view the IPv4 tab.
2 Select the Obtain an IP address automatically option to automatically enable DHCP and
disable manual settings.
Or
Select the Use the following IP address option to manually enter the settings.
a Enter the IPv4 Address in the IPv4 Address text box in the form xxx.xxx.xxx.xxx. The
default setting is ‘192.168.1.168’
b Select the Test button to ensure that the IP address is correct.
c Enter the Subnet Mask in the Subnet Mask text box xxx.xxx.xxx.xxx. The default set-
ting is ‘255.255.255.0’
d Enter the Gateway IP address in Gateway text box xxx.xxx.xxx.xxx.
e Enter the Preferred DNS Server IP address in the Preferred DNS Server text box.
f Enter the Alternate DNS Server IP address in the AlternateDNS Server text box.
3 Select the Save button to save the settings.
- End -
Procedure 7 Connecting to the camera using the static IP address
Step Action
1 The camera attempts to obtain an IP Address from the DHCP Server. When no DHCP
Server is available the camera is assigned a Static IP address of 192.168.1.168.