Installation Guide
Table Of Contents
- Warning
- Overview
- Tyco Illustra Pro 5MP Thermal Elevated Skin Temperature Detection Camera
- Network Topology
- Network Connection
- Live View
- Search
- Configuration
- Appendix A - Shutdown Procedure
- Appendix B: Using Media Player to View RTSP Streaming
- Appendix C: Technical Specifications
- Appendix D - Manufacturer and Local Contact Information
- Disclaimer and Regulatory
- EMC Information
- End User License Agreement (EULA)
14 8200-1953-09 A0
a Unlock the screw (1) (Figure 13) and pan the camera field of view up to 360 degrees.
b Unlock the screw (2) (Figure 13) to tilt the camera body up to 90 degrees.
c Unlock the screw (3) (Figure 13) and rotate the camera body up to 360 degrees.
Figure 13 Pan, tilt and rotate screws
Note:You must securely lock each screw to ensure that the camera holds the
modified position.
- End -
Procedure 4 Mounting the camera to a tripod stand
1 Install the tripod as per the instructions that come with it.
2 Align the four holes on the camera adaptor plate with the four holes on the camera base and
insert the four 4x10mm screws into the four holes and securely attach the camera adaptor
plate to the camera base.
Note:The camera is now attached to the camera adaptor plate.
3 Place the camera adaptor plate on top of the tripod stand and align the 1/4 “ threaded screw
connection underneath the camera adaptor plate with the threaded screw on the tripod
stand.
4 Rotate the camera adaptor plate to securely attach it to the tripod stand.
5 Insert all camera cables through the cable side entry notch on the camera base.
6 Attach the ferrite ‘round clamp’ to the large single camera cable.
Note:Ensure that the ferrite clamp (1) (Figure 10) is positioned close to the camera
base on the cable.
Note:The camera must be connected to earth ground.
7 Attach a ring-type terminal to the end of the ground wire (2) (Figure 11) (not provided). Insert
the machine screw through the ring terminal and attach to the camera (1) (Figure 11).