Installation Guide
Table Of Contents
- Warning
- Overview
- Tyco Illustra Pro 5MP Thermal Elevated Skin Temperature Detection Camera
- Network Topology
- Network Connection
- Live View
- Search
- Configuration
- Appendix A - Shutdown Procedure
- Appendix B: Using Media Player to View RTSP Streaming
- Appendix C: Technical Specifications
- Appendix D - Manufacturer and Local Contact Information
- Disclaimer and Regulatory
- EMC Information
- End User License Agreement (EULA)
Tyco Illustra Pro 5MP Thermal Elevated Skin Temperature Detection Camera Installation and Configuration
8200-1953-09 A0 13
Figure 11 Earth wire connection
9 To power up the camera:
• connect a 12V DC power supply to the power connector on the camera
cable
OR
• connect a shielded PoE cable to the ethernet / PoE slot on the camera
cable. Note: You must first attach the ferrite ‘rectangle clamp’ around
the Ethernet cable (1) (Figure 12). The cable (1) (Figure 12) must loop
around the clamp (2) (Figure 12) before the clamp is enclosed.
Figure 12 Cable looped inside the ferrite clamp
- End -
Procedure 2 Adjusting the sun shield
1 Loosen the thumb-screw (3) (Figure 4) to move the sun shield cover forward and backward
over the camera body.
Note:You must securely lock the thumb screw to ensure that the sun shield cover holds the modified
position.
- End -
Procedure 3 Adjusting the camera position
1 Use the L-key hexagonal wrench to: