Installation Guide
Table Of Contents
- Warning
- Overview
- Tyco Illustra Pro 5MP Thermal Elevated Skin Temperature Detection Camera
- Network Topology
- Network Connection
- Live View
- Search
- Configuration
- Appendix A - Shutdown Procedure
- Appendix B: Using Media Player to View RTSP Streaming
- Appendix C: Technical Specifications
- Appendix D - Manufacturer and Local Contact Information
- Disclaimer and Regulatory
- EMC Information
- End User License Agreement (EULA)
12 8200-1953-09 A0
Note:Remove the two screws on the camera cover (1) (Figure 7) to access the
buttons. Securely attach the cover when finished.
Table 9 Camera button descriptions and SD card slot
Number Cable connection description
1 Camera button cover
2 Micro SD Card Slot
3 Reset (Hold for more than 3 seconds)
Procedure 1 Mounting the camera to a wall or ceiling
1 Place the mounting template on the surface that you want to attach the camera.
2 On the surface drill four Ø 5mm holes and cut out a >30 Ø mm cable hole as per the
markings identified on the mounting template.
3 Securely place the four screw anchors into the four holes.
4 Place the camera cable through the cable hole on the mounting surface.
5 Hold the camera base (4) (Figure 4) up to the mounting template and align the four holes on
the camera base with the four holes on the mounting surface.
6 Insert the four PA4x25mm screws into the four holes on the camera base and securely
attach the camera to the mounting surface.
7 Attach the ferrite ‘round clamp’ to the large single camera cable.
Note:Ensure that the ferrite clamp (1) (Figure 10) is positioned close to the camera
base on the cable.
Figure 10 Round ferrite clamp position on the cable
Note:The camera must be connected to earth ground
8 Attach a ring-type terminal to the end of the ground wire (2) (Figure 11) (not provided). Insert
the machine screw through the ring terminal and attach to the camera (1) (Figure 11).