Installation Guide
Table Of Contents
- Overview
- Illustra PG4 Series 2MP, 4MP and 8MP Indoor / Outdoor Dome Cameras
- Network Topology
- Network Connection
- Configuration
- Appendix A: Using Media Player to View RTSP Streaming
- Appendix B: Stream Tables
- Appendix C:Technical Specifications
- End User License Agreement (EULA)
125 8200-2007-08 A0
Configuring Stored Audio
When connected to an appropriate device, the unit is capable of playing back stored audio when an
alarm has been triggered. A maximum of five audio files can be uploaded to the unit.
Note:Audio clips can only be used if a micro SD Card has been installed. Refer to the relevant Quick
Reference Guide for information on installing the micro SD Card.
When uploading an audio file it must meet the following requirements:
• The filename cannot contain spaces.
• It must be a ‘wav’ file with a ‘.wav’ extension.
• A single channel mono file with a bit depth of 16kHz.
• The sample rate must be 8kHz.
• The duration must be no longer than 20 seconds.
Procedure 161 Play Stored Audio
Step Action
1 Select Setup on the Web User Interface banner to display the setup menus.
2 Select Audio from the System menu.
3 Select the Audio Clips tab.
4 Select to play back the corresponding audio file.
- End -
Procedure 162 Upload an Audio File
Step Action
1 Select Setup on the Web User Interface banner to display the setup menus.
2 Select Audio from the System menu.
3 Select the Audio Clips tab.
4 Select Browse.
The Choose file dialog displays.
5 Navigate to the location where the audio file has been saved.
Select the audio file then select the Open button.
When uploading an audio file it must meet the following requirements:
• The filename cannot contain spaces.
• It must be a ‘wav’ file with a ‘.wav’ extension.
• A single channel mono file with a bit depth of 16kHz.
• The sample rate must be 8kHz.
• The duration must be no longer than 20 seconds.
6 Select Upload.
7 You will be prompted to confirm that you would like to upload the audio file.