Specifications

Setting Up Intellex Units
Configuration Guide 33
3 In Linear mode, move the slider to specify the percentage of database space used before an
option message appears.
Note
Notification is only used with linear recording.
Setting Up Alarms
1 From the Setup dialog, click Alarms.
2 From the General tab, set the alarm duration.
3 Click the corresponding radio button to set:
• Latch Messages—to require the operator to clear alarm messages manually from screen
using Utility > Clear Latched
• Alarm on Video Loss—to generate an alarm when the unit stops receiving video signal from
any camera
• Alarm Message Display—to display the ALARM message on the camera’s image when an
alarm occurs
• Unit Alarm Out—to energize alarm output 16 when any alarm event occurs
• Message Alert—to energize alarm output 16 when the unit is in linear mode and a notification
screen appears or unit is background archiving and a notification screen appears
• 15 Minute Index—to play back the video 15 minutes before an actual alarm.
Note
To use 15 Minute Index the camera must be actively recording and not in alarmed recording
mode.
4 Click the Quality tab.
a Click an option:
b Select the sensitivity and resolution. Higher sensitivity and resolution offer better quality but
less recording time.
c Click OK.
5 From the Alarms In Names tab, name each physical alarm input. Use these names when
reviewing alarm images and searching the alarm database.
6 From the Alarm Polarity tab, select the alarm polarity, the signal that triggers an alarm input.
Slider
Super highest image quality
Normal mid-range quality
Extended Record highest compression