Specifications

Setting Up Intellex Units
Configuration Guide 27
b Select the sensitivity and resolution. Higher sensitivity and resolution offer better quality but
less recording time.
c Click OK.
6 Select the Time tab. Set start times for day and night operation
.
7 Optionally, set up filters for each camera from the Camera tabs by selecting a live filter from
Day Filter and Night Filter. For more information, see:
• Setting Up Motion Detection on page 27.
• Setting Up Perimeter Detection on page 28.
• Setting Up Light Change on page 28.
• Setting Up Motion Exception on page 29.
8 Select a Data Lifetime Mode:
• Disabled prevents any scheduled deletion of video data (default).
• Select Cameras specifies individual cameras. Click Setup to display available cameras and
their data lifetime, then select individual cameras and data durations.
• All Cameras specifies the data duration for all cameras.
Setting Up Live Filters
For more information, see the User’s Guide.
Setting Up Motion Detection
1 From the Setup dialog, click Schedule.
2 From the Camera 1-8 and 9-16 tabs, choose Day Filter > Motion Detection.
3 Click Setup.
4 In the draw zone, click and draw the target area, or click All to select the entire area.
Note
Shapes must form an enclosed boundary; you can select multiple shapes. Choose Deactivate
to deselect a previously activated segment. Selecting All decreases the likelihood of triggering
an alarm since a greater percentage of the selected area must have motion to trigger an alarm.
5 Adjust sensitivity with the Sensitivity slider. Click Apply.
day
night