Specifications

19
Setting Up Intellex Units
Click Setup to access functions that enable you to set up and adjust each connected Intellex unit.
If the unit is protected with Classic Security, only Login is active on the Setup dialog.
If this unit has security, you must log in before continuing with setup options. Login is unavailable if
security is not set up.
Opening the Setup Dialog
1 If security is enabled, click Login in the Setup dialog.
2 Enter the system administrator’s PIN code, or your PIN code. Click each digit or type it in.
3 Click OK to accept the code.
Setting Up Cameras
1 Select an Intellex from the Instruments view.
2 Click Unit Setup or select Actions > Instrument Setup and login.
3 From the Setup dialog, click Cameras.
4 From the Names tab, name each camera.
5 From the Termination Tab, select 75
Ω or Hi-Z for each camera.
• Set the termination to 75
Ω if the loop through is not being used.
• Select the Hi-Z to pass the video signal to another device.
6 From the Gain Mode tab, adjust video signals that are too bright or dark:
Reduce Gain: Decrease the video signal
Normal: Default setting