Specifications

Illustra Flex 1MP & 3MP Outdoor Dome

2.2.5 Adjusting the camera position

The unit has three axes for positioning. While screening the picture on the monitor, adjust the position by

procedures below.

 Pan Adjustment (A): for wall mount and tilted ceiling rotate the lens base (360° maximum) until satisfied

with the field of view.

 Horizontal Rotation (B): rotate 3D assembly in the base, but do not turn assembly more than 360° as

this may have the internal cables twisted, disconnected, or broken.

 Tilt Adjustment (C): after loosening the thumbnuts, position the camera as desired, then finger –tighten

the thumbnuts to set the position.

Note

For Outdoor dome series:

Users can adjust zoom level and focus level manually according to the ambient condition.

Caution

Limitation for three axes position:

 Pan range: ±175°

 Tilt range: 25°～ 90°

 Rotate range: Manual Lens ±180° / Motorize Lens ±175°

FIGURE 2-7: ADJUSTING THE CAMERA POSITION

Caution

Retighten the locking screws to prevent slack after adjustment.