Quick Start Guide

Web GUI (continued)
Figure 10
5. Channel Select button – VLC Plug-in only: Selects one of three
camera streams for web GUI display. Note: Each sensor supports
up to three streams.
6. Camera Controls:
 PTZ Control / Preset – Not supported in web GUI.
 Speaker Control and MIC – Supported.
 Alarm Input / Relay Out - Supported.
7. Motion – Motion Detection indicator.
8. Camera Time - Displays the camera time.
Security
Camera Installation (continued)
Figure 6
Note: Ensure that the camera module angle does not exceed 60
degrees. See Figure 7.
Figure 7
6. Remove the inner protection film from the dome cover.
Camera Installation (continued)
6. Use the Torx wrench to securely attach the dome cover to the
camera base.
7. Remove the outer protective film from the dome cover to
complete the installation.
Camera cable port connections
See the camera cable port connections in Figure 8.
Figure 8
Figure 8: Camera cable port descriptions
1. Power: Connect the DC12V power cable to the power cable port
on the camera.
‘OR’
Network: Connect the camera's network cable to an 802.3at
PoE+ switch.
2. Audio Output: Connect the audio output device cable to the
‘Audio Output’ camera cable port on the camera.
3. Audio Input: Connect the audio input device cable to the ‘Audio
Input’ camera cable port on the camera.
4. Alarm Output: Connect the alarm output device cable to the blue
and grey cables on the camera ‘Alarm/Out’ cable.
5. Alarm Input: Connect the alarm input device cable to the yellow
and white cables on the camera ‘Alarm/In’ cable.
Web GUI
Note: Use IE10 (or above) or Chrome to access the camera web GUI.
See the web GUI screen layout in Figure 9 and their descriptions below.
Web GUI (continued)
Figure 9
1. Live video display – This is the cameras live video stream.
2. Setup button – Provides access to the configuration GUI.
(E.g. Video/Network/Events/Records/Security Configurations).
3. Select Viewer – Select individual video streams or Quad (VLC
plug-in only).
4. Live Viewer – Select one option: VLC plug-in or HTML (MJPEG).
See Figure 10.
Warnings
 This product is intended for professional installation, please follow
local wiring regulations.
 Do not install where children are likely to have access.
 Be sure to use only the standard adapter that is specified in the
specification sheet. Using any other adapter could cause fire,
electrical shock, or damage to the product.
 Incorrectly connecting the power supply or replacing battery may
cause explosion, fire, electric shock, or damage to the product.
 Do not connect multiple cameras to a single adapter. Exceeding
the capacity may cause abnormal heat generation or fire.
 Securely plug the power cord into the power receptacle. Insecure
connection may cause fire.
 When installing the camera, fasten it securely and firmly.
 Do not place conductive objects (e.g. screw drivers, coins, metal
things, etc.) or containers filled with water on top of the camera.
Doing so may cause personal injury due to fire, electric shock, or
falling objects.
 To prevent damage which may result in fire or electric shock
hazard, do not expose this appliance to rain or moisture.
© 2020 Johnson Controls. All rights reserved.
JOHNSON CONTROLS, TYCO and ILLUSTRA are trademarks and/or registered
trademarks. Unauthorized use is strictly prohibited.