Installation Guide
Table Of Contents
- Overview
- Illustra Flex Series 3MP and 8MP Indoor Dome Camera
- Illustra Flex Series 3MP and 8MP Outdoor Dome Camera
- Illustra Flex Series 3MP and 8MP Outdoor Bullet Cameras
- Illustra Flex Series 3MP and 8MP Indoor Box Camera
- Illustra Flex 3MP Outdoor Compact Mini Dome Camera
- Illustra Flex Series 2MP Indoor and Outdoor IR PTZ Camera
- Illustra Flex 2MP Indoor Micro Dome Camera
- Network Topology
- Network Connection
- Configuration
- Appendix A: User Account Access
- Appendix B: Using Media Player to View RTSP Streaming
- Appendix C: Stream Tables
- Appendix D: Camera Defaults
- End User License Agreement (EULA)
Illustra Flex Series Installation and Configuration Guide
8200-1456-01 M0 69
5 Securely attach the electronic control unit to the wall rear with the two (3mm x 25mm)
screws provided.
Note:Ensure that the lens module cable can reach the electronic control unit.
Figure 87 Attaching the electronic control unit and lens module with the cable
6 Plug the lens module cable into the electronic control unit.
WARNING
Depending on the material of your mounting surface, you may require different screws and
anchors than those as supplied. To prevent the unit from falling off, ensure that it is secured to a
firm place (ceiling slab or channel).
WARNING
The Electronic Control unit must not be mounted in a tightly enclosed area.
WARNING
The lens module must be connected to electronic control unit before powering on.
- End -
Procedure 34 Mounting the camera on to a ceiling with a ball type mount
Step Action
1 Use the (2) screws provided to attach the lens module to the camera mount.
2 Securely attach the electronic control unit above the ceiling with the two (3mm x 25mm)
screws provided.