Installation Guide
Table Of Contents
- Overview
- Illustra Flex Series 3MP and 8MP Indoor Dome Camera
- Illustra Flex Series 3MP and 8MP Outdoor Dome Camera
- Illustra Flex Series 3MP and 8MP Outdoor Bullet Cameras
- Illustra Flex Series 3MP and 8MP Indoor Box Camera
- Illustra Flex 3MP Outdoor Compact Mini Dome Camera
- Illustra Flex Series 2MP Indoor and Outdoor IR PTZ Camera
- Illustra Flex 2MP Indoor Micro Dome Camera
- Network Topology
- Network Connection
- Configuration
- Appendix A: User Account Access
- Appendix B: Using Media Player to View RTSP Streaming
- Appendix C: Stream Tables
- Appendix D: Camera Defaults
- End User License Agreement (EULA)
68 8200-1456-01 M0
Procedure 33 Mounting the camera into a ceiling or wall surface
For the behind a wall and into a surface from the front mounting configurations the Metal plate ring
should be attached to the lens module using the M2.5 screws and stand-offs if required at a clean
desk, table, or bench work area creating a camera module before going to the installation site.
Step 1, 2, 3 and 4 below should be performed before going to the installation site.
Step Action
1 Use the Torx T10 Security L-Key to remove the screw on the camera base and remove the
dome cover.
Figure 85 Removing the Micro Dome cover
2 Remove the plastic cover from the lens module.
3 Screw the three standoffs into the lens module threaded holes.
4 Attach the metal plate ring with the three (M2.5 x 0.45Px 4mm) screws so that the lens
module is securely attached.
Figure 86 Attaching the lens module and 'ring' plate to the wall