Installation Guide
Table Of Contents
- Overview
- Illustra Flex Series 3MP and 8MP Indoor Dome Camera
- Illustra Flex Series 3MP and 8MP Outdoor Dome Camera
- Illustra Flex Series 3MP and 8MP Outdoor Bullet Cameras
- Illustra Flex Series 3MP and 8MP Indoor Box Camera
- Illustra Flex 3MP Outdoor Compact Mini Dome Camera
- Illustra Flex Series 2MP Indoor and Outdoor IR PTZ Camera
- Illustra Flex 2MP Indoor Micro Dome Camera
- Network Topology
- Network Connection
- Configuration
- Appendix A: User Account Access
- Appendix B: Using Media Player to View RTSP Streaming
- Appendix C: Stream Tables
- Appendix D: Camera Defaults
- End User License Agreement (EULA)
66 8200-1456-01 M0
Procedure 32 Mounting the camera behind a wall
For the behind a wall and into a surface from the front mounting configurations the Metal plate ring
should be attached to the lens module using the M2.5 screws and stand-offs if required at a clean
desk, table, or bench work area creating a camera module before going to the installation site.
Step 1, 2, and 3 below should be performed before going to the installation site.
Step Action
1 Use the Torx T10 Security L-Key to remove the screw on the camera base and remove the
dome cover.
Figure 82 Removing the Micro Dome cover
2 Remove the plastic cover from the lens module.
3 Place the lens module into the hole in the 'ring' plate and securely rotate the three (M2.5 x
0.45Px 4mm) screws so that the lens module is securely attached to the 'ring' plate.
Figure 83 Attaching the lens module and 'ring' plate to the wall
4 Securely attach the three (3mm x 10mm) screws on the 'ring' plate to the wall rear.
5 Attach the 'ring' plate cover to the 'ring' plate on the front of the wall.
6 Securely attach the electronic control unit to the wall rear with the two (3mm x 25mm)
screws provided.