Installation Guide
Table Of Contents
- Overview
- Illustra Flex Series 3MP and 8MP Indoor Dome Camera
- Illustra Flex Series 3MP and 8MP Outdoor Dome Camera
- Illustra Flex Series 3MP and 8MP Outdoor Bullet Cameras
- Illustra Flex Series 3MP and 8MP Indoor Box Camera
- Illustra Flex 3MP Outdoor Compact Mini Dome Camera
- Illustra Flex Series 2MP Indoor and Outdoor IR PTZ Camera
- Illustra Flex 2MP Indoor Micro Dome Camera
- Network Topology
- Network Connection
- Configuration
- Appendix A: User Account Access
- Appendix B: Using Media Player to View RTSP Streaming
- Appendix C: Stream Tables
- Appendix D: Camera Defaults
- End User License Agreement (EULA)
Illustra Flex Series Installation and Configuration Guide
8200-1456-01 M0 49
Procedure 23 Adjusting the Position
The unit has three axes for positioning, refer to Figure 57 on page 49. While monitoring, adjust the
position as below.
Step Action
1 Pan Adjustment (A) For Wall Mount and Tilted Ceilings:
a Rotate the lens base (maximum 140°) until you are satisfied with the field of view.
2 Horizontal Rotation (B):
a Rotate 3D assembly in the base. Do not turn assembly more than 354° as this
assembly may cause the internal cables to twist and disconnect or break.
3 Tilt Adjustment (C):
a Tilt the lens base (maximum 125° from the frontal mounting surface) until you are sat-
isfied with the field of view.
CAUTION
Limitation of three axis positions of lens centroid:
• Pan range: 140°
• Tilt range: 15° to 125° from frontal mounting surface
• Rotate (z-axis): 354°
Figure 57 Adjusting the position of the camera