Installation Guide
Table Of Contents
- Overview
- Illustra Flex Series 3MP and 8MP Indoor Dome Camera
- Illustra Flex Series 3MP and 8MP Outdoor Dome Camera
- Illustra Flex Series 3MP and 8MP Outdoor Bullet Cameras
- Illustra Flex Series 3MP and 8MP Indoor Box Camera
- Illustra Flex 3MP Outdoor Compact Mini Dome Camera
- Illustra Flex Series 2MP Indoor and Outdoor IR PTZ Camera
- Illustra Flex 2MP Indoor Micro Dome Camera
- Network Topology
- Network Connection
- Configuration
- Appendix A: User Account Access
- Appendix B: Using Media Player to View RTSP Streaming
- Appendix C: Stream Tables
- Appendix D: Camera Defaults
- End User License Agreement (EULA)
Illustra Flex Series Installation and Configuration Guide
8200-1456-01 M0 47
Procedure 21 Disassembling the Camera
Step Action
1 Remove the bungs from the camera base and remove the screws from the top of the camera
with a safety screwdriver (4).
2 Gently remove the top cover (3).
3 Set the top cover aside.
Note:Unscrew the top cover safety wire to fully remove the top cover.
Figure 55 Disassembling the Compact Mini Dome camera
- End -
Procedure 22 Mounting the camera
Step Action
1 Use the mounting template to mark holes that correspond to the camera base on the mount-
ing surface.
2 Drill holes.
3 Fasten the anchors to the mounting surface with screws.
4 Secure the unit bottom case to the wall or ceiling with tapping screws.
5 Adjust the viewing angle.