Installation Guide
Table Of Contents
- Overview
- Illustra Flex Series 3MP and 8MP Indoor Dome Camera
- Illustra Flex Series 3MP and 8MP Outdoor Dome Camera
- Illustra Flex Series 3MP and 8MP Outdoor Bullet Cameras
- Illustra Flex Series 3MP and 8MP Indoor Box Camera
- Illustra Flex 3MP Outdoor Compact Mini Dome Camera
- Illustra Flex Series 2MP Indoor and Outdoor IR PTZ Camera
- Illustra Flex 2MP Indoor Micro Dome Camera
- Network Topology
- Network Connection
- Configuration
- Appendix A: User Account Access
- Appendix B: Using Media Player to View RTSP Streaming
- Appendix C: Stream Tables
- Appendix D: Camera Defaults
- End User License Agreement (EULA)
42 8200-1456-01 M0
Note:The power source needs to be NEC Class 2 or LPS. The PoE connection should be provided
by a UL Listed product and the connections shall be made in accordance with Article 800 of the NEC
or local regulations.
CAUTION
If using DCsupply, make sure the polarity is correct. Incorrect connection can cause malfunction
and/or damage.
- End -
Procedure 20 Mounting the camera
To mount the camera, complete the following steps:
Step Action
1 Attach the camera unit to a pendant mount (not supplied), and insert and tighten the screws
on the tripod receptacle into the screw holes on the base.
2 Mount the camera unit onto the ceiling or wall and fasten securely.
3 Connect the Safety Wire (Fall Prevention Wire, not supplied). One end connects to the wall
or ceiling and the other connects to the safety-cord screw of the camera unit.
NOTE
Depending on the material of the mounting surface, different screws and anchors than those
supplied may be required. To prevent the unit from falling off, ensure that it is mounted to a firm
place, such as a ceiling slab or channel, using a safety wire strong enough to withstand the total
weight of the unit. Safety wire must be connected with one end the wall or ceiling and the other to the
safety cord screw of the unit. This helps prevent the unit from falling.
- End -