Installation Guide
Table Of Contents
- Overview
- Illustra Flex Series 3MP and 8MP Indoor Dome Camera
- Illustra Flex Series 3MP and 8MP Outdoor Dome Camera
- Illustra Flex Series 3MP and 8MP Outdoor Bullet Cameras
- Illustra Flex Series 3MP and 8MP Indoor Box Camera
- Illustra Flex 3MP Outdoor Compact Mini Dome Camera
- Illustra Flex Series 2MP Indoor and Outdoor IR PTZ Camera
- Illustra Flex 2MP Indoor Micro Dome Camera
- Network Topology
- Network Connection
- Configuration
- Appendix A: User Account Access
- Appendix B: Using Media Player to View RTSP Streaming
- Appendix C: Stream Tables
- Appendix D: Camera Defaults
- End User License Agreement (EULA)
196 8200-1456-01 M0
3 Reconnect the power supply and power up the camera.
- End -
Procedure 203 Unmount the Micro SD Card for Removal
Step Action
1 Select Setup on the Web User Interface banner to display the setup menus.
2 Select SD Card Management menu from the Edge Recording menu.
3 Select Unmount.
You are prompted to confirm the unmounting.
4 Select OK to confirm.
OR
5 Select Cancel.
Remove the Micro SD card from the camera.
AVI clips are not available on the camera until the Micro SD card has been inserted and
mounted.
- End -
Record Settings
Select which video stream to use for alarm video and configure pre and post event durations for the
playable video clip. The camera can record video generated from MD, face detection and DIO
events.
Procedure 204 Configure Record Settings
Step Action
1 Select Setup on the Web User Interface Banner to display the setup menus.
2 Select Record Settings from the Edge Recording menu.
3 Select Enable Record to allow the camera to create a playable video clip.
OR
Deselect Enable Record to disable the feature.
4 If Enable Record has been enabled:
a Select the required video stream from the Video drop-down menu.
Refer to Procedure 5-1 Configure the Video Stream Settings.
b Select the Pre Event (secs) in seconds from the drop-down menu. Values range from 0
to 10.
The default setting is 5 seconds.
c Select the Post Event (secs) in seconds from the drop-down menu. Values range from 0
to 10.
The default setting is 5 seconds.
5 Select Apply to save.
- End -