Installation Guide

Illustra Flex Series Installation and Configuration Guide
8200-1456-01 M0 188
• Manually
• via NTP
The default setting is ‘Manually’.
7 If you select Manually in step 5:
c Select the Date (DD/MM/YYYY) using the drop-down menus.
d Select the Time (HH:MM:SS) using the drop-down menus.
8 If you select via NTP in step 5:
a Enter the NTP Server Name in the text box.
- End -
Audio
Note:This section does not apply to the Compact Mini Dome and Micro Dome.
You can configure the audio input, output, upload audio and stored audio clips, as well as configure
Audio Video Synchronisation on this tab.
Procedure 187 Configure Audio Input
Step Action
1 Select Audio from the System menu. The Audio Input tab displays.
2 Select the Input Enable check box to enable the audio input settings.
Or
Clear the Input Enable check box to disable audio input settings.
The default setting is ‘Disabled’.
3 Use the slider bar to select the Input Volume.
Values range from 1 to 100.
The default setting is 72.
- End -
Procedure 188 Configuring Audio Output
Step Action
1 Select Audio from the Camera Configuration menu.
2 Select the Output Enable check box to enable the audio output settings.
Or
Deselect the Output Enable check box to disable audio input settings.
The default setting is ‘Disabled’.
3 If Output Enable has been enabled, use the slider bar to select the Output Volume.
Values range from 1 to 100.
The default setting is 50.