Installation Guide
Table Of Contents
- Overview
- Illustra Flex Series 3MP and 8MP Indoor Dome Camera
- Illustra Flex Series 3MP and 8MP Outdoor Dome Camera
- Illustra Flex Series 3MP and 8MP Outdoor Bullet Cameras
- Illustra Flex Series 3MP and 8MP Indoor Box Camera
- Illustra Flex 3MP Outdoor Compact Mini Dome Camera
- Illustra Flex Series 2MP Indoor and Outdoor IR PTZ Camera
- Illustra Flex 2MP Indoor Micro Dome Camera
- Network Topology
- Network Connection
- Configuration
- Appendix A: User Account Access
- Appendix B: Using Media Player to View RTSP Streaming
- Appendix C: Stream Tables
- Appendix D: Camera Defaults
- End User License Agreement (EULA)
Illustra Flex Series Installation and Configuration Guide
8200-1456-01 M0 184
Note:Network settings, presets, patterns and sequences can be retained if required.
Procedure 179 Resetting the Camera
Step Action
1 Select Setup on the Web User Interface banner to display the setup menus.
2 Select Maintenance from the System menu.
3 Select the Preserve IP address check box to retain the current network settings during the
camera reset.
OR
Deselect the Preserve IP address check box to restore the default networking settings.
The default setting is ‘Enabled’.
4 Select Reboot
You will be prompted to confirm the camera reset.
• Select OK to confirm. The Web User Interface will display a “Camera
Resetting” page with a progress bar showing the reboot progress.
• When the camera is restarted it will take 2 - 3 minutes until it is online
and ready to be accessed and controlled.
OR
Select Cancel.
5 The Log in page displays.
- End -
Reboot
To perform a physical reset of the camera, refer to the chapter regarding your camera model in this
guide.
Procedure 180 Reboot the Camera
Step Action
1 Select Setup on the Web User Interface banner to display the setup menus.
2 Select Maintenance from the System menu.
3 Select Reboot.
You will be prompted to confirm the camera reboot.
4 Select OK to confirm.
The Web User Interface will display a “Camera Rebooting” page with a progress bar
showing the reboot progress.
When the camera is restarted it will take 2 - 3 minutes until it is online and ready to be
accessed and controlled.
OR
Select Cancel.
5 The Log in page displays.