Installation Guide

Illustra Flex Series Installation and Configuration Guide
8200-1456-01 M0 180
- End -
SNMP
The camera introduces support for the Simple Network Management Protocol making it easier to
manage on an IP network.
The SNMP support includes support for V2 and V3. Using V2 means no authentication is required to
access the data and results are unencrypted. V3 offers enhanced encryption and authentication
security features.
Procedure 176 Configure SNMP Settings
Step Action
1 Select Setup on the Web User Interface banner to display the setup menus.
2 Select SNMP from the Network menu.
3 Enter a location reference in the Location text box.
4 Enter an SNMP managing contact reference in the Contact text box.
5 If using V2:
a Select the Enable V2 checkbox.
b Enter the authorized ID for reading SNMP data in the Read Community text box.
c Enter the Trap Community.
d Enter the Trap Address.
e Select Apply.
OR
If using V3:
a Select the Enable V3 checkbox.
b Enter the Read User.
c Select the Security Level from the drop down menu:
- noauth: No authentication / no encryption.
- auth: Authentication / no encryption. A user password is required. It is symmetrically
encrypted using either MD5 or SHA.
- priv: Authentication / encryption. A user password is required as is symmetrically
encrypted using either MD5 or SHA. A data encryption password is required as is sym-
metrically encrypted using either DES or AES.
d Select the Authentication Type using the radio buttons.
e Enter the Authentication Password
f Select the EncryptionType using the radio buttons.
g Enter the Encryption Password
h Select Apply.
- End -