Installation Guide

179 8200-1456-01 M0
Procedure 174 Test the FTP Settings
Step Action
1 Select Setup on the Web User Interface banner to display the setup menus.
2 Select FTP from the Network menu.
3 Select the FTP tab.
4 Select Test. A sample text file will be sent to the specified FTP destination to confirm that
FTP settings are correct.
- End -
SMTP
Configure the SMTP settings to allow e-mail alerts to be sent from the camera when an analytic alert
is triggered.
Note:SMTP settings must be configured to enable email alerts when using analytics.
Procedure 175 Configure SMTP Settings
Step Action
1 Select Setup on the Web User Interface banner to display the setup menus.
2 Select SMPT from the Network menu.
The SMPT tab displays.
3 Check the Enable SMPT check box to enable SMPT. Text boxes on the tab become
available for entry.
Note:When in Enhanced Security mode, enabling SMTP requires the admin
account password.
4 Enter the IP Address of the mail server in the Mail Server text box.
5 Enter the server port in the Server Port text box.
The default setting is ‘25’.
6 Enter the from email address in the From Address text box.
7 Enter the email address to send email alerts to in the Send Email to text box.
8 Select the Use authentication to log on to server check box to allow authentication
details to be entered.
OR
Clear the Use authentication to log on to server to disable authentication.
The default setting is ‘Disabled’.
9 If ‘Use authentication to log on to server’ check box has been selected:
a Enter the username for the SMTP account in the Username text box.
b Enter the password for the SMTP account in the Password text box.
10 Select Apply to save the settings.