Installation Guide
Table Of Contents
- Overview
- Illustra Flex Series 3MP and 8MP Indoor Dome Camera
- Illustra Flex Series 3MP and 8MP Outdoor Dome Camera
- Illustra Flex Series 3MP and 8MP Outdoor Bullet Cameras
- Illustra Flex Series 3MP and 8MP Indoor Box Camera
- Illustra Flex 3MP Outdoor Compact Mini Dome Camera
- Illustra Flex Series 2MP Indoor and Outdoor IR PTZ Camera
- Illustra Flex 2MP Indoor Micro Dome Camera
- Network Topology
- Network Connection
- Configuration
- Appendix A: User Account Access
- Appendix B: Using Media Player to View RTSP Streaming
- Appendix C: Stream Tables
- Appendix D: Camera Defaults
- End User License Agreement (EULA)
175 8200-1456-01 M0
Network Menu
When you select the Network menu, the TCP/IP page displays, as seen in Figure 122 on page 175.
Figure 122 Network Menu
The Network Menu provides access to the following camera settings and functions:
• TCP/IP
• FTP
• SMTP
• SNTP
• CIFS
• Dynamic DNS
TCP/IP
Configure the IPv4 and IPv6 settings on the camera.
IPv4
Configure the IPv4 settings for the camera.
Note:When you perform a factory reset or reboot the unit searches for the last known IP address. If
this is not available it reverts to the default IP address of 192.168.1.168. This could result duplicate
IP addresses. Refer to Network Menu on page 175 for more information.