Installation Guide
Table Of Contents
- Overview
- Illustra Flex Series 3MP and 8MP Indoor Dome Camera
- Illustra Flex Series 3MP and 8MP Outdoor Dome Camera
- Illustra Flex Series 3MP and 8MP Outdoor Bullet Cameras
- Illustra Flex Series 3MP and 8MP Indoor Box Camera
- Illustra Flex 3MP Outdoor Compact Mini Dome Camera
- Illustra Flex Series 2MP Indoor and Outdoor IR PTZ Camera
- Illustra Flex 2MP Indoor Micro Dome Camera
- Network Topology
- Network Connection
- Configuration
- Appendix A: User Account Access
- Appendix B: Using Media Player to View RTSP Streaming
- Appendix C: Stream Tables
- Appendix D: Camera Defaults
- End User License Agreement (EULA)
163 8200-1456-01 M0
Procedure 146 Disable Enhanced Security Mode
Step Action
1 Select Setup on the Web User Interface banner to display the setup menus.
2 Select Security Status from the Security menu.
3 Select the Security Overview tab.
Note:When in Enhanced Security mode, changing the security mode requires the
admin account password.
4 Click Apply.
Note:Any changes to the Security mode are logged in the Security Log.
- End -
Security Status
This section summarizes the communication protocols that are used and their status. The following
communication protocols can be enabled: HTTP, FTP, CIFS, Dyn DNS, SMTP, HTTPS, SNMP
V1/2, SNMP V3, uPNP, and SFTP.
Security Overview
Procedure 147 Enable/Disable Communication Protocols
Step Action
1 Select Setup on the Web User Interface banner to display the setup menus.
2 Select Security Status from the Security menu.
3 Select the Security Overview tab.
4 Select or clear the Protocols check box to enable or disable that protocol.
5 Click Apply to save your settings.
Note:
When in Enhanced Security, enabling/disabling individual protocols requires the
admin account password.
Any changes to individual protocol settings are logged in the Security Log.
Security Log
The security log records any changes made to the security mode or to an individual protocol.
Procedure 148 Display Security Log
Step Action
1 Select Setup on the Web User Interface banner to display the setup menus.
2 Select Security Status from the Security menu.
3 Select the Security Log tab.