Installation Guide

Illustra Flex Series Installation and Configuration Guide
8200-1456-01 M0 157
2 If the stream settings are modified the motion detection is disabled and it is necessary to
enable motion detection again if required.
3 Motion detection can only be enabled on a video stream that uses H.264 with a resolution on
1920x1440 or lower.
Procedure 139 Create a Motion Detection Alert
Step Action
1 Select Setup on the Web User Interface banner to display the setup menus.
2 Select Analytics from the Events and Actions menu.
3 Select the Enable motion detection check box to enable Motion Detection on the camera.
OR
Clear the Enable motion detection check box to disable Motion Detection on the camera.
4 Select the zone for detection in the Motion zone drop-down list.
5 Select the Enable motion zone check box to enable the zone for motion detection.
6 Select Edit in the Region configuration field.
7 Use the drawing tools on the Motion Detection Configuration Pane to draw the region of
interest on the pane. Multiple selections can be made.
Note:The IR PTZ camera does not support the Motion Zones feature.
8 Select the sensitivity from the Sensitivity drop-down menu:
• Highest
• High
• Medium
• Low
• Lowest
9 Select the fault action from the Action drop-down menu.
This fault action activates when motion is detected in the selected region of interest.
Refer to the Create a Fault Action procedure if a fault action has not yet been defined.
10 Select Apply to save the changes.
- End -
Enable or Disable a Motion Detection Alert
Motion detection can be turned on and turned off when required.
Procedure 140 Enable or Disable a Motion Detection Alert
Step Action
1 Select Setup on the Web User Interface banner to display the setup menus.
2 Select Analytics from the Events and Actions menu.
3 Select the Motion Detection tab.
The Motion Detection Configuration pane displays.