Installation Guide

Illustra Flex Series Installation and Configuration Guide
8200-1456-01 M0 146
Procedure 123 Activate a Sequence
Step Action
1 Select Setup on the Web User Interface banner to display the setup menus.
2 Select Sequences from the PTZ menu.
The Sequences tab displays.
3 Select to start the video stream if it is not already active.
The video pane will display the current camera view.
4 Select to activate the corresponding sequence.
The video pane will update to display the selected sequence.The sequence will run
continuously until interrupted by a camera command, pattern, preset, scan or alarm.
- End -
Editing a Sequence
Edit an existing sequence.
Procedure 124 Edit a Sequence
Step Action
1 Select Setup on the Web User Interface banner to display the setup menus.
2 Select Sequences from the PTZ menu.
The Sequences tab displays.
3 Select to edit the corresponding sequence.
The sequence will open in the Edit Sequence tab.
4 Edit the sequence name in the Sequence Name text box if required.
5 Select to edit the corresponding preset. The following can be edited:
• Preset Name: To add a new preset to the sequence, move to the next
available free slot and select a preset from the Preset Name drop-
down menu.
• Dwell time
6 If required, select to remove the corresponding preset from the sequence.
7 Select Add to save the changes
OR
Select Cancel.
8 Select Apply to save the changes.
- End -