Installation Guide

143 8200-1456-01 M0
3 Select the Repeat tab.
The Repeat tab displays.
4 Select the Repeat Pattern check box to allow the selected pattern to repeat continuously.
OR
Deselect the Repeat Pattern check box to allow the selected pattern to run only once.
The default setting is ‘Enabled’.
- End -
Scans
A scan allows you to program left and right scan limits to automate surveillance activities. Once
these scan limits are programmed, you can choose to run a smooth scan, stepped scan, orrandom
scan. When active, the scan repeats until interrupted by a camera command, preset, pattern oralarm.
Setting Scan Limits
Set left and right scan limits on the camera.
Procedure 119 Set Scan Limits
Step Action
1 Select Setup on the Web User Interface banner to display the setup menus.
2 Select Scans from the PTZ menu.
The Scans tab displays.
3 Select to start the video stream if it is not already active.
The video pane will display the current camera view.
4 Adjust the camera view as required to locate the left scan limit.
5 Select Set Left to set the displayed position as the left limit.
6 Adjust the camera view as required to locate the right scan limit.
7 Select Set Right to set the displayed position as the right limit.
The scan limits have been set and the selected scan will now run within the scan limits set.
8 Select the pause time for a Stepped Scan from the Pause drop-down menu.
The settings are 2-10. The default is 2.
- End --
Set Scan Limits to Default Settings
Return the camera to the default scan settings.