Installation Guide

Illustra Flex Series Installation and Configuration Guide
8200-1456-01 M0 140
• White Balance
• Picture Balance
• Wide Dynamic Range (WDR)
• IR/DayNight
• Shutter Limit
9 Select Add to save the updated preset.
You will be prompted to confirm the update.
10 Select OK to save the changes.
OR
Select Cancel.
Deleting a Preset
Delete an existing preset position from the camera.
Procedure 114 Delete a Preset
Step Action
1 Select Setup on the Web User Interface banner to display the setup menus.
2 Select Preset from the PTZ menu.
The Preset tab displays.
3 Select to delete the corresponding preset.
You will be prompted to confirm the deletion.
Note:You cannot delete a preset while it is associated with another camera function. To remove the
preset, refer to the associated camera function.
4 Select OK to confirm the deletion.
OR
Select Cancel.
- End -
Patterns
A pattern is a series of pan, tilt and zoom movements which can be saved to the camera. A
maximum of 16 user programmable patterns can be programmed forthe camera with an unlimited
duration.
Note:The Illustra Pro PTZ provides Apple Peel, which is a predefined pattern stored on the camera
by default that covers the entire viewing area. This pattern slowly pans 360° starting at the ceiling
line. It then tilts 30° and pans 360° again, repeating until the entire viewing area is covered. The
pattern will repeat continuously until interrupted by a camera command, preset, scan or alarm.