Installation Guide

137 8200-1456-01 M0
Procedure 108 Setting the Zoom Stops
Step Action
1 Select Setup on the Web User Interface banner to display the setup menus.
2 Select PTZ Parameters from the PTZ Settings menu.
3 In the Zoom Stops section use the drop box to change the First Zoom Stop setting. The
default first zoom stop setting is 30X.
- End -
Home
Home allows you to adjust the Home Position Type. The home position is a preset, pattern or
scan/sequence that automatically runs after a designated period of camera inactivity. Use this option
if you want to keep a specific area under surveillance when the camera is not moving.
Procedure 109 Configure the Home Position
Step Action
1 Select Setup on the Web User Interface banner to display the setup menus.
2 Select PTZ Parameters from the PTZ Settings menu.
3 Select the Home tab.
4 Select the Home Position Type:
• Preset
• Pattern
• Sequence
• Scan
• None
The default is None.
If an action is selected, chose the type of action to perform from the Parameter drop-down
menu that is enabled.
5 Use the slider bar to select the Return Time (mins).
The default is 5.
6 Select Apply to save the settings.
- End --
Procedure 110 Clear the Home Position
1 Select Setup on the Web User Interface banner to display the setup menus.
2 Select PTZ Parameters from the PTZ Settings menu.
3 Select the Home tab.
4 Select None from Home Position Type.
5 Select Apply to save the settings.