Installation Guide

Illustra Flex Series Installation and Configuration Guide
8200-1456-01 M0 136
Procedure 106 Enable/Disable Automatic Flip
Step Action
1 Select Setup on the Web User Interface banner to display the setup menus.
2 Select PTZ Parameters from the PTZ Settings menu.
3 Select the PTZ Parameters tab.
4 Select the Automatic Flip check box to enable automatic flip.
OR
Deselect the Automatic Flip check box to disable automatic flip.
The default setting is ‘Enabled’.
- End --
Return Settings
When calling a Preset, the camera adopts the settings uniquely created forthat Preset. When an
operatormoves the camera from its Preset position, the camera can return to global settings only if
programmed to do so through the Return Settings page.
Procedure 107 Enable/Disable Return Settings
Step Action
1 Select Setup on the Web User Interface banner to display the setup menus.
2 Select PTZ Parameters from the PTZ Settings menu.
3 Select the PTZ Parameters tab.
4 Select the corresponding check box to enable the return settings for:
• Return to Auto Focus
• Return to Previous
OR
Deselect the corresponding check box to disable the setting.
The default setting is ‘Enabled’.
- End -
Zoom Stops
The Zoom Stops define how the digital zoom function is partitioned.
Note:The Zoom Stop will not be used if EIS is enabled.
The Illustra Flex IR PTZ camera has a 30x optical zoom with a 12X digital zoom resulting in a
maximum possible zoom of 360X. The first zoom stop can be selected and is defaulted to 30x (end of
Optional zoom). The last stop is 360x (but its not configurable ). Pressing Zoom In continuously
causes the zoom to stop at 30X. Renewing the zoom in command lets the user navigate to 360x.