Installation Guide

124 8200-1456-01 M0
Procedure 86 Configure Exposure Settings
Step Action
1 Select Setup on the Web User Interface banner to display the setup menus.
2 Select the Picture Settings tab from the Basic Configuration menu.
3 Select to start the video stream if it is not already active.
4 Select the Exposure Mode from the drop-down menu:
• P-Iris
• Manual
• Shutter Priority
• Iris Priority
5 Select the Exposure Method from the drop-down menu:
• Full Picture Weighted
• Upper
• Lower
• Center Weighted
• Spot
• Left
• Right
The default setting is Center Weighted.
6 Select the Min Exposure from the drop-down menu.
The default setting is 1/10000s.
7 Select the Max Exposure from the drop-down menu.
The default setting is 1/8s.
8 Select the Exposure Offset (F-Stops) from the drop-down menu.
The default setting is 0.
9 Select the Max Gain from the drop-down menu.
The default settingis 51db.
10 Select the Iris Level from the drop-down menu.
The default setting is 1.
Note:The Iris Level differs depending on the camera.
11 Select the Frequency radio button for either 50Hz or 60Hz.
The default setting is 60Hz.
12 Select or clear the check box for Flickerless Mode.
This feature is not selected by default.
• When you select Flickerless Mode, the minimum and maximum
exposure times are locked to 1/100 and 1/50 respectively (PAL) or
1/120 and 1/60 respectively (NTSC). This applies to all cameras ref-
erenced in this guide.
- End -