Installation Guide
Table Of Contents
- Overview
- Illustra Flex Series 3MP and 8MP Indoor Dome Camera
- Illustra Flex Series 3MP and 8MP Outdoor Dome Camera
- Illustra Flex Series 3MP and 8MP Outdoor Bullet Cameras
- Illustra Flex Series 3MP and 8MP Indoor Box Camera
- Illustra Flex 3MP Outdoor Compact Mini Dome Camera
- Illustra Flex Series 2MP Indoor and Outdoor IR PTZ Camera
- Illustra Flex 2MP Indoor Micro Dome Camera
- Network Topology
- Network Connection
- Configuration
- Appendix A: User Account Access
- Appendix B: Using Media Player to View RTSP Streaming
- Appendix C: Stream Tables
- Appendix D: Camera Defaults
- End User License Agreement (EULA)
Illustra Flex Series Installation and Configuration Guide
8200-1456-01 M0 110
Lens Calibration
Use the lens calibration process to recover focus and zoom after motor stalling has occurred. Motor
step stalling is rare, but it can occur during shipping or through mishandling of the camera. If the One
Touch focus at Wide or Tele is not working through the zoom range, the camera requires lens
calibration. The lens calibration tool uses infinity focus curves to align the camera lens and correct
problems focusing at Wide or Tele.
Lens calibration is automatic and you can run it from the Lens Calibration tab.
This feature applies only to the Illustra Flex 3MP Indoor Dome, Outdoor Dome, and Bullet cameras.
Procedure 73 Run a Lens Calibration
Step Action
1 Select Setup on the Web Interface Banner to display the setup menus.
2 Select Picture Settings from the Video menu.
3 Select the Lens Calibration tab.
4 Select Start Calibration and wait for the camera lens initialization to complete.
5 To confirm the success of the lens calibration, select the Picture Basic tab from the
Picture Settings menu and verify that the image is in focus through the zoom range.
Use the OneTouch button to automatically focus the area.
- End -
Lens Selection
You can select the lens on the Illustra Flex Box camera. The lens models supported appear on the
Lens Selection tab of the Video menu.
Procedure 74 Perform a Lens Selection
Step Action
1 Select Setup on the Web Interface Banner to display the setup menus.
2 Select Picture Settings from the Video menu.
3 Select the Lens Selection tab.
4 In the Lens Model field, use the drop-down list to select the lens you installed.
5 When you change lenses, you are prompted to reboot the camera. All active sessions will be
lost. Select OK to proceed with reboot.
- End -
Date / Time / OSD
Change the camera name, date and time and enable OSD.
Camera Name
The camera name displays on the Web User Interface banner and the on-screen display for the
camera. This name also displays when using Illustra Connect or ONVIF.