Installation Guide

105 8200-1456-01 M0
Note:The Iris Level differs depending on the camera.
Note:P-Iris is not applicable to the PTZ camera.
12 Select the Frequency radio button for either 50Hz or 60Hz.
The default setting is 60Hz.
13 Select or clear the check box for Flickerless Mode.
This feature is not selected by default.
• When you select Flickerless Mode, the minimum and maximum
exposure times are locked to 1/100 and 1/50 respectively (PAL) or
1/120 and 1/60 respectively (NTSC). This applies to all cameras ref-
erenced in this guide.
- End -
Procedure 64 Restore Exposure Defaults
Step Action
1 Select Setup on the Web User Interface banner to display the setup menus.
2 Select the Picture Settings tab from the Basic Configuration menu.
3 Select to start the video stream if it is not already active.
4 Select Exposure Defaults to restore the default settings.
- End -
Setting Auto Focus
Enable or disable auto focus. Continuous Auto Focus is a PTZ camera feature that the user can
use to control the camera auto-focusing on a static field of view. When auto-focus is on the camera
focuses on the moving object.
Note:Continuous Auto Focus is applicable to the PTZ camera.
Procedure 65 Enable/Disable Auto Focus
Step Action
1 Select Setup on the GUI banner to display the setup menus.
2 Select the Picture Basic tab from the Basic Configuration menu.
3 Select the Auto Focus check box to enable auto focus. OR
Deselect the Auto Focus check box to disable auto focus.
The default setting is ‘Enabled’.
- End -
Picture Additional
Configure Wide Dynamic Range, Day Night Mode, and Picture Adjustments including Brightness,
Contrast, White Balance, Saturation and Sharpness which displays in the video pane.