Installation Guide

Illustra Flex Series Installation and Configuration Guide
8200-1456-01 M0 104
Procedure 63 Configure Exposure Settings
Step Action
1 Select Setup on the Web User Interface banner to display the setup menus.
2 Select the Picture Settings tab from the Basic Configuration menu.
3 Select to start the video stream if it is not already active.
4 Select the Exposure Mode from the drop-down menu:
• P-Iris
• Manual
• Shutter Priority
• Iris Priority
Note:Settings available depend on the Exposure Mode configuration you choose. P-Iris and Iris
Priority are not applicable to the PTZ camera.
5 Select the Exposure Method from the drop-down menu:
• Full Picture Weighted
• Upper
• Lower
• Center Weighted
• Spot
• Left
• Right
The default setting is center weighted.
6 Select the Min Exposure from the drop-down menu.
The default setting is 1/10000s.
Note:Min Exposure is not applicable to the PTZ camera.
7 Select the Max Exposure from the drop-down menu.
The default setting is 1/8s.
Note:Max Exposure is not applicable to the PTZ camera.
8 Select the Exposure (sec) from the drop-down menu.
The default setting is 1/8s.
Note:Exposure (sec) is only applicable to the PTZ camera.
9 Select the Exposure Offset (F-Stops) from the drop-down menu.
The default setting is 0.
10 Select the Max Gain (or Manual Gain if configuring the PTZ camera) from the drop-down
menu.
The default setting is 51db.
11 Select the Iris Level from the drop-down menu.
The default setting is 1.