Quick Start Guide

ManualsBrandsAmerican Dynamics ManualsPTZ Cameras2 Megapixel IR Outdoor PTZ Camera, 30X Lens

Table Of Contents

Accessing the connector pins

A. Remove the two screws located on the top cover (1) (Figure 4) to open it.

Figure 4

Security

Quick Start Guide

(8200-1456-10_F0)

Illustra Flex Gen 2 PTZ Cameras

In the box

 1 x Network PTZ Camera

 1 x Printed Quick Start Guide

 1 x Printed Regulatory document

 1 x NTSC/PAL output female BNC cable

 1 x 2 position 3mm euro style plug

 1 x Torx 20 Security L-Key

 1 x Torx 6 Security L-Key

 1 x Torx 10 Security L-Key

 1 x 12-pin terminal connector for I/O function

 1 x Safety cable (Pre-attached to the camera)

Installation tools

 1 x Drill

 1 x Screw drivers

 1 x Wire cutters

Quick reference

 Default IP: 192.168.1.168 (DHCP enabled)

 Default Username and Password: admin

Note: For PTZ units that include a bubble ensure that all bubble packaging is

removed before powering up the unit. Also, remove the additional packaging inside

the bubble cap.

Pictorial Index of the camera (IFS02P6INWITB / IFS02P6ONWITB)

Figure 1

Table 1: Pictorial index descriptions

Button / connections

Description

NPT Pendant Cap

Screws (x2) to open and lock the top cover

Top cover

Camera lens

Camera head

Removing the bubble from the camera (IFS02P6ISWTTB)

Note: This is only applicable to specific indoor units with bubble.

A. Remove the three screws located on the camera head (1) (Figure 2).

Figure 2

Removing the bubble from the camera (IFS02P6ISWTTB

(continued)

B. Carefully remove the bubble unit (1) (Figure 3)

Figure 3

Figure 3: Location and descriptions of the buttons / connections

Figure 5

Summary of content (2 pages)

PAGE 1
Table 1: Pictorial index descriptions Security Button / connections 1 Quick Start Guide (8200-1456-10_F0) Illustra Flex Gen 2 PTZ Cameras Description NPT Pendant Cap 2 Screws (x2) to open and lock the top cover 3 Top cover 4 Camera lens 5 Camera head In the box Removing the bubble from the camera (IFS02P6ISWTTB)           Note: This is only applicable to specific indoor units with bubble. A. Remove the three screws located on the camera head (1) (Figure 2).
PAGE 2
Installing the rubber cable seal in to the NPT pendant cap A. Securely place the rubber cable seal (1) (Figure 6) into the NPT pendant cap (2) (Figure 6). Security Inserting or removing the micro SD card (continued) Note: It is advised that you reboot the camera after inserting the micro SD card. C. Secure the two screws (1) (Figure 7) located on the micro SD card cover. Installing the mount adaptor on to the NPT pendant cap A.