User`s manual
Table Of Contents
- DigiMux User's Manual, English
- DigiMux User's Manual, English
- Table of Contents
- Overview
- System Installation
- Basic Operations
- Front Panel Controls
- Viewing Live and Playback Video Images
- Record and Playback Operation
- Recording
- Quick Record Setting Changes
- Playback Operations
- Playback Controls
- Date/Time Video Playback
- Single Step Advance and Reversing Playback Direction
- Event List Playback
- The Event List
- Event Recording and Playback
- Pre-Alarm Availability
- The Event List Display
- Playing Back Video from the Event List
- Deleting an Event from the List in Playback Mode
- Deleting a Page from the Event List
- Covert Cameras
- Dome Control
- Dome Control Signals Installation
- Basic Alarm Features
- Advanced Operations
- System Information and Administration
- Maintenance
- Glossary
- Appendices
- Appendix A: Account Access and Priorities
- Appendix B: Connector Pin Assignments
- Appendix C: Technical Specifications
- Appendix D: Optional Connections and Installation
- Optional Connections
- Audio Connection
- IP Address Setup Information
- Dial-Up Connections via Modem
- Establishing the Dial-Out Connection: DigiMux to a PC
- Establishing the Dial-In Connection: PC to a DigiMux
- Using the Dial-Up Connections
- Connecting Extended Storage Module (ESM) Units
- Disconnecting Extended Storage Module (ESM) Units
- Additional Installation Information
- Appendix E: DigiRemote
- Appendix F: DigiMux Digital Signatures
- Appendix G: Using ControlCenter 200/300 Keyboards
- Appendix H: Troubleshooting Guide
- Index
DigiMux
System Information and Administration 83
From the Administrator Setup menu, select Dome Protocol and press Enter. The
following menu is displayed:
This menu contains the names of all cameras connected to the DigiMux unit. To
configure dome protocol for a specific camera, select the camera name and press
Enter. The following menu is displayed:
Specify the dome protocol and ID in this menu:
NOTE: If you have a system with multiple units, camera domes, and keyboard
devices installed on the same RS-485 bus, take care that each device has its
own unique ID address.
Dome Protocol
1 01 10 10
2 02 11 11
3 03 12 12
4 04 13 13
5 05 14 14
6 06 15 15
7 07 16 16
8 08
9 09
Dome Protocol
01
1 Dome Protocol NONE
2 Dome ID 001
MENU ITEM DESCRIPTION
Dome Protocol Enables you to select the communications protocol associated
with your dome camera. Select one of the following
communications protocols using the Direction keys: AD422,
Pelco
D, Pelco P, Dynacolor, or None (default).
Dome ID Allows you to enter the address of the dome. This ID number
must match the ID address set by the dome. See your dome’s
documentation for the address setting. The default assignment
is
001.