User`s manual
Table Of Contents
- DigiMux User's Manual, English
- DigiMux User's Manual, English
- Table of Contents
- Overview
- System Installation
- Basic Operations
- Front Panel Controls
- Viewing Live and Playback Video Images
- Record and Playback Operation
- Recording
- Quick Record Setting Changes
- Playback Operations
- Playback Controls
- Date/Time Video Playback
- Single Step Advance and Reversing Playback Direction
- Event List Playback
- The Event List
- Event Recording and Playback
- Pre-Alarm Availability
- The Event List Display
- Playing Back Video from the Event List
- Deleting an Event from the List in Playback Mode
- Deleting a Page from the Event List
- Covert Cameras
- Dome Control
- Dome Control Signals Installation
- Basic Alarm Features
- Advanced Operations
- System Information and Administration
- Maintenance
- Glossary
- Appendices
- Appendix A: Account Access and Priorities
- Appendix B: Connector Pin Assignments
- Appendix C: Technical Specifications
- Appendix D: Optional Connections and Installation
- Optional Connections
- Audio Connection
- IP Address Setup Information
- Dial-Up Connections via Modem
- Establishing the Dial-Out Connection: DigiMux to a PC
- Establishing the Dial-In Connection: PC to a DigiMux
- Using the Dial-Up Connections
- Connecting Extended Storage Module (ESM) Units
- Disconnecting Extended Storage Module (ESM) Units
- Additional Installation Information
- Appendix E: DigiRemote
- Appendix F: DigiMux Digital Signatures
- Appendix G: Using ControlCenter 200/300 Keyboards
- Appendix H: Troubleshooting Guide
- Index
User’s Manual
78 System Information and Administration
Items in this menu are described in the following table:
MENU ITEM DESCRIPTION
Change Passcode Allows you to change the User or Admin passcode to any 4-
digit number accessible via the front panel. Use the Camera
keys to input the new passcode, and then press Esc. The new
passcode is saved in non-volatile memory.
A passcode is a combination of single digits in the range of 1 to
10, inclusive (10 = 0 on DigiClient).
NOTE: You must choose numbers for your passcode that
correspond to the buttons available on your front panel.
Otherwise, you cannot log in to the DigiMux unit using
the front panel. For example, on a four-channel unit,
you are limited to the numbers 1, 2, 3, and 4. You may
repeat digits in the 4-digit passcode sequence.
NOTE: Remember your password. Write it down on the card in
the front of this manual and keep the card in a
convenient place. If you forget your password or
cannot find your card, please call your Customer
Service Representative and/or visit
www.americandynamics.net/DigiMux.
Covert Playback Allows you to turn on/off covert camera in playback. Yes
allows video playback from covert cameras. No displays no
video from covert cameras in playback. The default setting is
Yes.
Language Allows you to select another language for the OSD Menu and
screen messages. Language selection takes effect immediately
upon selection. Press Left/Right to select English, French,
German, Italian, or Spanish. The default setting is English.
LAN Setup Allows you to configure the LAN setup for the DigiMux. See
LAN Setup on page 79.
Unit Name Allows you to assign a name to the DigiMux unit. Use the
Direction keys and the Enter key to select characters from the
virtual keyboard and press Esc to establish the name.
RS-485 Setup Allows you to change the RS-485 ID address of the DigiMux
unit and to set up the parameters of the RS-485 Port.
See RS-485 Setup on page 81.
Dome Protocol Allows you to configure dome protocol and dome ID. See Dome
Protocol on page 82.