User`s manual

DigiMux
Advanced Operations 73
When your selected settings are saved or loaded, DigiMux responds with a
confirmation message.
Saving and Loading Unit Configuration Settings
You can export the unit configuration settings to an external drive, such as a USB
ThumbDrive, for later import on the same or another unit. This action can save
considerable time in configuring multiple DigiMux units.
NOTE: Be aware that you must assign each unit a unique IP address and a unique
RS-485 Unit Address. Remember to change these settings after you import a
configuration.
Saving a Unit Configuration (Export Configuration)
To save a configuration, make sure the device to which you are saving the
configuration, such as a USB Flash Drive, is attached to the unit. Select Export Config
from the Save/Load Configuration menu and press Enter. The following menu is
displayed:
Load Factory Passcode Reloads the factory passcode in the event that the
administrator cannot remember or locate the
passcode. Select Yes to load the factory passcode,
or No to cancel. The factory passcode is 1234 for
Administrator and 4321 for User.
Import Config Loads a unit configuration that was saved to an
external drive, such as a USB ThumbDrive. For
more information, see
Loading a Unit Configuration
(Import Configuration) on page 74.
Export Config Saves a unit configuration by exporting it to an
external drive, such as a USB Flash Drive. For
more information, see
Saving a Unit Configuration
(Export Configuration) on page 73, below.
MENU ITEM DESCRIPTION
Export Configuration
1 Copy Destination Import Configuration
2 Export Config Name
3 Begin