User`s manual
Table Of Contents
- DigiMux User's Manual, English
- DigiMux User's Manual, English
- Table of Contents
- Overview
- System Installation
- Basic Operations
- Front Panel Controls
- Viewing Live and Playback Video Images
- Record and Playback Operation
- Recording
- Quick Record Setting Changes
- Playback Operations
- Playback Controls
- Date/Time Video Playback
- Single Step Advance and Reversing Playback Direction
- Event List Playback
- The Event List
- Event Recording and Playback
- Pre-Alarm Availability
- The Event List Display
- Playing Back Video from the Event List
- Deleting an Event from the List in Playback Mode
- Deleting a Page from the Event List
- Covert Cameras
- Dome Control
- Dome Control Signals Installation
- Basic Alarm Features
- Advanced Operations
- System Information and Administration
- Maintenance
- Glossary
- Appendices
- Appendix A: Account Access and Priorities
- Appendix B: Connector Pin Assignments
- Appendix C: Technical Specifications
- Appendix D: Optional Connections and Installation
- Optional Connections
- Audio Connection
- IP Address Setup Information
- Dial-Up Connections via Modem
- Establishing the Dial-Out Connection: DigiMux to a PC
- Establishing the Dial-In Connection: PC to a DigiMux
- Using the Dial-Up Connections
- Connecting Extended Storage Module (ESM) Units
- Disconnecting Extended Storage Module (ESM) Units
- Additional Installation Information
- Appendix E: DigiRemote
- Appendix F: DigiMux Digital Signatures
- Appendix G: Using ControlCenter 200/300 Keyboards
- Appendix H: Troubleshooting Guide
- Index
User’s Manual
70 Advanced Operations
Condition Settings
4. Select Condition 1 from the Motion Detection menu (or Condition 2, if you are
defining that condition) for the camera and press Enter.
The Condition selection dialog is displayed. It is the same for Condition 1 or 2.
Condition
1 is shown below:
Detection Area Setup
5. Select a camera from the list and press Enter.
The Detect Area is displayed. This area allows you to set the detection area for
each camera. The detection area consists of 192 (16x12) detection grids (squares)
The Detect Area is displayed in the following figure:
6. Use the Direction keys to select each grid, or square. Press Enter to enable or
disable a grid (see the figure above). Press Set to select all of the grids for the
image. Press Set again to de-select all of the grids.
7. When all of the desired grids are selected, press Esc.
Condition 1
1 01 10 10
2 02 11 11
3 03 12 12
4 04 13 13
5 05 14 14
6 06 15 15
7 07 16 16
8 08
9 09
Motion Detection 1
Camera 01
005