User`s manual

DigiMux
Advanced Operations 67
E-Mail Notification
The e-mail message provides the name and IP address information of the DigiMux
unit on which an alarm occurred. The nature of the alarm, the associated camera, and
time and date are included in the body of the e-mail message. Currently, there is no
option to select the time zone in which the unit is located. The DigiMux specifies the
time at which the e-mail was sent based on Greenwich Mean Time (GMT). This
Internet e-mail is dependent on many external factors, such as DNS server setup and
network traffic. The time between alarm occurrence and message receipt will vary
and depends on your network setup.
You can enter only one e-mail address. If multiple address notification is needed, you
can set up a distribution list address. A distribution list address contains a group of e-
mail addresses. When a message is sent to the distribution list address, all addresses
contained within it receive that message. For information on setting up a distribution
list address, see the online documentation for your e-mail application.
Pager Number
The Pager Number option enables you to enter the number of a pager that the unit
dials for event/alarm notification. From the Administrator Setup menu, select Pager
Number and press Enter. The following menu is displayed:
Enter the pager number by pressing the corresponding Camera keys. If the unit is
dialing a touch tone pager, enter the number only. If you are using a pager service
provider and a pause in the number is required, enter a p. When the number is
completed, press ESC to exit the menu.
The pager number is dialed when an alarm is triggered and Pager Notice is ON. For
information on Pager Notice, see
Event Response on page 61.
NOTE: Pager Notice requires an external USB Modem, or an RS-232 Modem with a
USB to RS-232 converter. A dedicated analog standard POTS line is also
required. Do not use a PBX or digital line with this modem.
Pager Number
0 1 2 3 4 5 6 7 8 9 p
<space> Prev Next