User`s manual

User’s Manual
66 Advanced Operations
The items in the Set up menu are described in the following table:
Determining Your PCs IP Address
In order to set up the DigiAlert remote notification from the DigiMux unit, you must
know your PCs IP address. To determine your PCs IP address, follow these steps:
1. From the Start menu on your PC, select Run.
2. In the Open field of the Run box, enter cmd and click OK.
A Windows command line box is displayed.
3. Enter ipconfig /all at the command prompt and press Enter or Return.
The IP Address is listed in the command line box. Note this address for the IP
Address menu item entry on the DigiMux OSD menu.
MENU ITEM DESCRIPTION
DigiAlert IP Allows you to enter the IP Address of the PC on which the
DigiAlert software is installed. Press Enter to select this
menu item. Press Left/Right to change values, and
Up/Down to move to the next value. Enter returns to the
Set Up menu items. See
Determining Your PCs IP Address,
below.
E-Mail Address Allows you to enter the E-mail address to which alarm
event information is sent, if this capability is enabled. Use
the virtual keyboard to enter the address. For information
on the virtual keyboard, see
Entering Character Strings In
Menus on page 38.
NOTE: In order to enable E-mail notification, you must
have a valid DNS address.
Pager Number Allows you to enter the number of a pager that the unit
dials for event/alarm notification, if this capability is
enabled. For more details, see
Pager Number, below.
Also, see Entering Character Strings In Menus on page 38.
Dial-Out Phone No
(Number)
Allows you to enter the phone number that the unit dials
via modem for event/alarm notification, if this capability
is enabled. For more details, see
Dial-Out Phone No
(Number) on page 68.
Also, see Entering Character Strings In Menus on page 38.